Telenetics MIU202T Manuel d'utilisateur télécharger pdf (Page 19)

MIU202T Installation, Operation & Diagnostics Edition: April 4, 1998 Page 17

13. DIAGNOSTICS

The following pages provide hardware techniques for diagnosing communication

problems and thereby isolating the problem at the local modem, the remote

modem or the interconnecting line.

(a) LOCAL ANALOG LOOPBACK (Figure 2)

Requires a loop back cable with a built-in circuit for line loss to simulate a

typical leased line condition (See Figure 3).

Connect the loop back cable to the RJ11 connector on the modem under test.

Set Dip Switches as follows…

Switch 7 = OFF 4-Wire

Switch 9 = ON Soft Carrier Turn Off Enabled

Switch 1 = ON Transmit (TxA) Signal Level = 0dBm

Switch 3 = ON Receive (RxA) Signal Level = –33dBm

Switch 6 = OFF Switched Carrier

Switch 4&5 = ON RTS/CTS Delay = 50ms

Test 1: RTS/CTS Analog Control

Set RTS “ON” and check that CD (Carrier Detect) turns “ON”.

Turn RTS “OFF” and ensure that CD turns “OFF”

With RTS “ON”, run a test message at TxD and verify that the

same message is received at RxD with no data errors.

Test 2: Transmit Signal Power & Receive Levels

Set Dip Switch 1 OFF (TxA = -10dBm)

CD will be OFF.

Change Dip Switch 1 to ON (TxA = 0dBm)

CD should now be ON.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26

Pas de commentaire

Telenetics MIU202T Manuel d'utilisateur Page 19